ECIS4500 series Web Management Guide R02

Command Descriptions
317
2.5.3 VeriPHY
Press to run the diagnostics. This will take approximately 5 seconds. If all ports are
selected, this can take approximately 15 seconds. When completed, the page refreshes automatically,
and you can view the cable diagnostics results in the cable status table. Note that VeriPHY is only
accurate for cables of length 7 - 140 meters.
10 and 100 Mbps ports will be linked down while running VeriPHY. Therefore, running VeriPHY on a 10
or 100 Mbps management port will cause the switch to stop responding until VeriPHY is complete.
After pressing , following table show up.
Object
Description
Port
The port where you are requesting VeriPHY Cable Diagnostics.
Cable Status
Port:
Port number.
Pair: