ECIS4500 series Web Management Guide R02

326
2.6.4.3 Upload
It is possible to upload a file from the web browser to all the files on the switch, except default-config,
which is read-only.
Select the file to upload, select the destination file on the target, then click .
If the destination is running-config, the file will be applied to the switch configuration. This can be done in
two ways:
- Replace mode: The current configuration is fully replaced with the configuration in the uploaded file.
- Merge mode: The uploaded file is merged into running-config.
If the file system is full (i.e. contains the three system files mentioned above plus two other files), it is not
possible to create new files, but an existing file must be overwritten or another deleted first.