ECIS4500 Quick Start Guide R01

ECIS4500 Quick Installation Guide

Ethernet Interface (RJ-45 Ethernet)

The switch provides two types of Ethernet interfaces: electrical (RJ-45) and optical (SFP) interfaces.

Connecting the Ethernet interface via RJ-45:

●

To connect the switch to a PC, use straight-through or cross-over Ethernet cables,

●

To connect the switch to an Ethernet device, use UTP (Unshielded Twisted Pair) or STP (Shielded

Twisted Pair) Ethernet cables.

The pin assignment of RJ-45 connector is shown in the following figure and table.

ECIS4500-6T2F/6T4F/8T2F

ECIS4500-8P2T4F/8P4F/4P2T2F/4P4T

Ethernet Interface (Fiber, SFP)

For both 100/1000 Mbps fiber speed connections, the SFP slots are available. The SFP slot accepts the

fiber transceivers that typically have an LC connector.

The fiber transceivers have options of multimode, single mode, long-haul or special-application

transceivers.

DANGER: Never attempt to view optical connectors that might be emitting laser energy.

Do not power up the laser product without connecting the laser to the optical fiber and

putting the dust cover in position, as laser outputs will emit infrared laser light at this point.

Pin Assignment PoE Assignment

1,2 T/Rx+,T/Rx- Positive V

Port

3,6 T/Rx+,T/Rx- Negative V

Port

4,5 T/Rx+,T/Rx- X

7,8 T/Rx+,T/Rx- X

Pin Assignment

1,2 T/Rx+,T/Rx-

3,6 T/Rx+,T/Rx-

4,5 T/Rx+,T/Rx-

7,8 T/Rx+,T/Rx-