ECIS4500 Quick Start Guide R01

ECIS4500 Quick Installation Guide
12
CLI Initialization and Configuration (Optional)
1. Connecting to the Ethernet port (RJ-45 Ethernet port) of managed switch
2. Key-in the command under Telnet: telnet 192.168.2.10
3. Login with default account and password.
4. Username: admin;
Password: admin
Change the IP with commands listed below:
CLI Command:
LED STATUS INDICATIONS
LED Indicator /color Condition
P1/P2
On Green P1/P2 power line has power
Off P1/P2 power line disconnect or does not have power
Alarm
On Red Ethernet link fails, alarm or power failure alarm occurs
Off No Ethernet link fails and no power failure alarm
Copper port Link/Act
On Green Ethernet link up but no traffic is detected
Flashing Green Ethernet link up and there is traffic detected
Off Ethernet link down
Copper port Speed
On Yellow A 1000 Mbps connection is detected
Off No link, a 10 Mbps or 100 Mbps connection is detected
SFP port Link/Act
On Green Ethernet link up
Off Ethernet link down
SFP port Speed
On Yellow SFP port speed 1000 Mbps connection is detected.
Off No link or a SFP port speed 100 Mbps connection is
PoE LED
On Yellow PoE is detected
Off No link
enable
configure terminal
interface vlan 1
ip address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
exit