(AS7926-40XKFB) Quick Start Guide R01
– 1 –
Quick Start Guide
1. QSFP28 Port LEDs:
■
Blue — 100G
■
Yellow — 40G
■
Cyan — 2 x 50G
■
Magenta — 4 x 25G
■
Green — 4 x 10G
2. QSFP-DD Port LEDs:
■
Blue — 400G
3. System LEDs:
■
SYS/LOC — Green (OK)
■
DIAG — Green (OK), Red (fault detected)
■
PWR — Green (OK), Amber (fault)
■
FAN — Green (OK), Amber (fault)
4. Management Port LEDs:
■
SFP+ OOB Port — Green (10G), Amber (1G)
■
RJ-45 OOB Port — Right (link), Left (activity)
1
3
2
4
4
E082021-CS-R01
150000000075A
100G Aggregation Router
AS7926-40XKFB
1.
AS7926-40XKFB
2. Rack mounting kit
3. 2 x Power cord
4. Console cable—RJ-45 to D-Sub
5. Documentation—Quick Start Guide (this document) and Safety
and Regulatory Information
Fan Tray Replacement
1. Press the release latch in the
fan tray handle.
2. Pull out to remove the fan.
3. Install replacement fan with
matching airflow direction.
PSU Replacement
1. Remove the power cord.
2. Press the release latch and
remove the PSU.
3. Install replacement PSU with
matching airflow direction.
Fan Tray Replacement
1. Press the release latch in the
fan tray handle.
2. Pull out to remove the fan.
3. Install replacement fan with
matching airflow direction.
PSU Replacement
1. Remove the power cord.
2. Press the release latch and
remove the PSU.
3. Install replacement PSU with
matching airflow direction.
Package Contents
Overview
FRU Replacement
1 2 3 4 5
Status LEDs
1. 40 x 100G QSFP28 ports
2. 13 x 400G QSFP-DD fabric ports
3. Air filters
4. Product tag
5. 2 x RJ-45 Stack-Sync ports
6. Timing Ports: 2 x RJ-45 PPS/ToD, 1PPS/10MHz connector
7. Management I/O: 1000BASE-T RJ-45, 2 x 10G SFP+, RJ-45/
Micro USB console, USB storage, reset button, 7-segment display
8. 2 x AC PSUs
9. Grounding screw
10. 5 x fan trays
1
2
1
3
10
8
7
3
5
6
4
9
7
Air Filter Replacement
Air Filter Replacement
1. Unscrew the filter cover captive screws.
2. Remove the old filter and install a replacement filter.
3. Replace the filter cover and tighten the captive screws.
www.edge-core.com
*150000000075A_R01*