AS5800-EC Series CLI Reference Guide R02

Chapter 22 | Data Center Bridging Commands
DCB Exchange Commands
– 540 –
◆ On a port set to manual mode, only locally configured settings are used to
construct DCBX TLVs. On these ports, the operational mode, traffic classes, and
bandwidth information must be specified by the operator. These ports
advertise their configuration to their peer if DCBX is enabled on that port. Any
incompatible peer configurations received on these ports are logged and an
error counter incremented.
Example
The following example sets DCBX mode to auto-upstream on port 5:
Console(config)#interface ethernet 1/5
Console(config-if)#dcbx mode auto-up
Console(config-if)#
show dcbx This command shows the DCBX configuration settings and status of the LLDP TLV
willing bits.
Syntax
show dcbx [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-54)
port-channel channel-id (Range: 1-27)
Default Setting
Shows DCBX configuration settings for all ports.
Command Mode
Privileged Exec
Example
This example displays the DCBX administrative status, operational mode, and the
status of the LLDP TLV willing bit for ETS and PFC.
Console#show dcbx ethernet 1/5
DCBX Port Configuration
Port Status Mode ETS Willing PFC Willing
-------- -------- ------------------- ----------- -----------
Eth 1/5 Enabled AutoUpstream No No
Console#