AS5800-EC Series CLI Reference Guide R02

Chapter 18 | Spanning Tree Commands
– 459 –
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When this command is enabled on an interface, topology change information
originating from the interface will still be propagated.
This command should not be used on an interface which is purposely configured in
a ring topology.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#spanning-tree tc-prop-stop
Console(config-if)#
spanning-tree
protocol-migration
This command re-checks the appropriate BPDU format to send on the selected
interface.
Syntax
spanning-tree protocol-migration interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-54)
port-channel channel-id (Range: 1-27)
Command Mode
Privileged Exec
Command Usage
If at any time the switch detects STP BPDUs, including Configuration or Topology
Change Notification BPDUs, it will automatically set the selected interface to forced
STP-compatible mode. However, you can also use the spanning-tree protocol-
migration command at any time to manually re-check the appropriate BPDU
format to send on the selected interfaces (i.e., RSTP or STP-compatible).
Example
Console#spanning-tree protocol-migration eth 1/5
Console#