AS5800-EC Series CLI Reference Guide R02

Chapter 11 | Interface Commands
Transceiver Threshold Configuration
– 373 –
Transceiver Threshold Configuration
transceiver-threshold-
auto
This command uses default threshold settings obtained from the transceiver to
determine when an alarm or warning message should be sent. Use the no form to
disable this feature.
Syntax
transceiver-threshold-auto
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold-auto
Console#
transceiver-monitor This command sends a trap when any of the transceiver’s operational values fall
outside of specified thresholds. Use the no form to disable trap messages.
Syntax
transceiver-monitor
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 389).
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (page 470).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 470).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
(page 467).
Native VLAN Indicates the default Port VLAN ID (page 471).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames (page 502).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 468).
Table 68: show interfaces switchport - display description (Continued)
Field Description