AS5800-EC Series CLI Reference Guide R02

Chapter 11 | Interface Commands
Interface Configuration
– 362 –
Command Usage
Statistics are only initialized for a power reset. This command sets the base value for
displayed statistics to zero for the current management session. However, if you log
out and back into the management interface, the statistics displayed will show the
absolute value accumulated since the last power reset.
Example
The following example clears statistics on port 5.
Console#clear counters ethernet 1/5
Console#
hardware profile
portmode
This command configures port settings for 40G operation.
Syntax
hardware profile portmode interface {1x40g | 4x10g | reset}
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-54)
1x40g - Configures the port as a single 40G port.
4x10g - Configures the port as four 10G ports.
reset - Configures port mode to the default setting.
Default Setting
AS5812-54X-EC/54T-EC: The example under the show hardware profile portmode
command shows the default settings for these switches.
Command Mode
Privileged Exec
Command Usage
◆ 40G ports can be configured as a single port connected with 40G QSFP fiber
cable, 40G DAC (direct attach) cable, or breakout cable that connects a 40G port
to four 10G ports. Refer to the installation Guide for more information on how to
use these cable types.
◆ Four 10G ports can also be configured as a single 40G port using breakout
cable. Refer to the installation Guide for more information on how to use this
cabling option.