AS5800-EC Series CLI Reference Guide R02

Chapter 8 | Authentication Commands
802.1X Port Authentication
– 237 –
General Commands
dot1x default This command sets all configurable dot1x authenticator global and port settings to
their default values.
Command Mode
Global Configuration
Example
Console(config)#dot1x default
Console(config)#
dot1x eapol-pass-
through
This command passes EAPOL frames through to all ports in STP forwarding state
when dot1x is globally disabled. Use the no form to restore the default.
Syntax
[no] dot1x eapol-pass-through
Default Setting
Discards all EAPOL frames when dot1x is globally disabled
Command Mode
Global Configuration
Command Usage
This command resets the following commands to their default settings:
dot1x operation-mode Allows single or multiple hosts on an dot1x port IC
dot1x port-control Sets dot1x mode for a port interface IC
dot1x re-authentication Enables re-authentication for all ports IC
dot1x timeout quiet-period Sets the time that a switch port waits after the Max Request
Count has been exceeded before attempting to acquire a
new client
IC
dot1x timeout re-authperiod Sets the time period after which a connected client must
be re-authenticated
IC
dot1x timeout supp-timeout Sets the interval for a supplicant to respond IC
dot1x timeout tx-period Sets the time period during an authentication session that
the switch waits before re-transmitting an EAP packet
IC
Information Display Commands
show dot1x Shows all dot1x related information PE
Table 43: 802.1X Port Authentication Commands (Continued)
Command Function Mode