AS5800-EC Series CLI Reference Guide R02

Chapter 5 | System Management Commands
Event Logging
– 153 –
show line This command displays the terminal line’s parameters.
Syntax
show line [console | vty]
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
Shows all lines
Command Mode
Normal Exec, Privileged Exec
Example
To show all lines, enter this command:
Console#show line
Console Configuration:
Password Threshold : 3 times
EXEC Timeout : 600 seconds
Login Timeout : 300 seconds
Silent Time : Disabled
Baud Rate : 115200
Data Bits : 8
Parity : None
Stop Bits : 1
VTY Configuration:
Password Threshold : 3 times
EXEC Timeout : 600 seconds
Login Timeout : 300 sec.
Silent Time : Disabled
Console#
Event Logging
This section describes commands used to configure event logging on the switch.
Table 20: Event Logging Commands
Command Function Mode
logging facility Sets the facility type for remote logging of syslog messages GC
logging history Limits syslog messages saved to switch memory based on
severity
GC
logging host Adds a syslog server host IP address that will receive
logging messages
GC
logging on Controls logging of error messages GC