AS5800-EC Series CLI Reference Guide R02

Chapter 5 | System Management Commands
File Management
– 132 –
◆ The switch supports only two operation code files, but the maximum number
of user-defined configuration files is 16.
◆ You can use “Factory_Default_Config.cfg” as the source to copy from the
factory default configuration file, but you cannot use it as the destination.
◆ To replace the startup configuration, you must use startup-config as the
destination.
◆ The Boot ROM and Loader cannot be uploaded or downloaded from the FTP/
TFTP server. You must follow the instructions in the release notes for new
firmware, or contact your distributor for help.
◆ For information on specifying an https-certificate, see “Replacing the Default
Secure-site Certificate” in the Web Management Guide. For information on
configuring the switch to
use HTTPS for a secure connection, see the ip http
secure-server
command.
◆ When logging into an FTP server, the interface prompts for a user name and
password configured on the remote server. Note that “anonymous” is set as the
default user name.
Example
The following example shows how to download new firmware from a TFTP server:
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config; 2. opcode; 3. license: 2
Source file name: as5812_12185181.swi
Destination file name: as5812_12185181.swi
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#
The following example shows how to upload the configuration settings to a file on
the TFTP server:
Console#copy file tftp
Choose file type:
1. config; 2. opcode; 3. license: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#