Web Management Guide

Table Of Contents
Chapter 19
| Multicast Routing
Configuring PIM for IPv4
– 620
Figure 422: Configuring a PIM RP Candidate
To display settings for an RP candidate:
1.
Click Routing Protocol, PIM, SM.
2.
Select RP Candidate from the Step list.
3.
Select Show from the Action list.
4.
Select an interface from the VLAN list.
Figure 423: Showing Settings for a PIM RP Candidate
Displaying the PIM
BSR Router
Use the Routing Protocol > PIM > PIM-SM (Show Information – Show BSR Router)
page to display Information about the bootstrap router (BSR).
Parameters
These parameters are displayed:
IP Address
– IP address of interface configured as the BSR.
Uptime
– The time this BSR has been up and running.
Priority
– Priority value used by this BSR candidate.