Web Management Guide

Chapter 12 | Basic Administration Protocols
Simple Network Management Protocol
– 367 –
3. Select Show Community from the Action list.
Figure 219: Showing Community Access Strings
Configuring Local
SNMPv3 Users
Use the Administration > SNMP (Configure User - Add SNMPv3 Local User) page to
authorize management access for SNMPv3 clients, or to identify the source of
SNMPv3 trap messages sent from the local switch. Each SNMPv3 user is defined by
a unique name. Users must be configured with a specific security level and
assigned to a group. The SNMPv3 group restricts users to a specific read, write, and
notify view.
Parameters
These parameters are displayed:
◆ User Name – The name of user connecting to the SNMP agent. A maximum of
three local users can be configured. (Range: 1-32 characters)
◆ Group Name – The name of the SNMP group to which the user is assigned.
(Range: 1-32 characters)
◆ Security Model – The user security model; SNMP v1, v2c or v3.
◆ Security Level – The following security levels are only used for the groups
assigned to the SNMP security model:
■
noAuthNoPriv – There is no authentication or encryption used in SNMP
communications. (This is the default security level.)
■
AuthNoPriv – SNMP communications use authentication, but the data is
not encrypted.
■
AuthPriv – SNMP communications use both authentication and
encryption.
◆ Authentication Protocol – The method used for user authentication.
(Options: MD5, SHA; Default: MD5)
◆ Authentication Password – A minimum of eight plain text characters is
required.