Quick Start Guide-R02

Quick Start Guide
– English 2 –
4. Connect Power
Install one or two universal AC or DC PSUs in the switch.
Connect an external AC or DC power source to the PSUs.
36 – 72 VDC Return
-36 – -72 VDC
Chassis Ground
Caution: Use a UL/IEC/EN 60950-1 certified power supply
to connect to a DC converter, and a #18 AWG (for 36–72 VDC
PSU).
5. Verify Switch Operation
Verify basic switch operation by checking the system LEDs.
When operating normally, the PSU1/PSU2 and System LEDs
should all be on green.
6. Perform Initial Configuration
ONIE Installer Software
If the network operating system (NOS) installer is located on
a network server, first connect the RJ-45 Management
(Mgmt) port to the network using Category 5, 5e or better
twisted-pair cable. (Not required if the NOS installer is
located on attached storage.)
Boot the switch. Wait for the ONIE software to locate and
execute the NOS installer, and then wait for the installer to
load the NOS software image.
Subsequent switch boots will bypass ONIE and directly run
the NOS software.
Note: Refer to NOS installer and NOS documentation for
details on software location options and set up for ONIE.
1
2
5
3
4
1
2
3
4
5
1
1
1
2
7. Connect Network Cables
For RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
For AS4610-30P, ports 1-16 can suport PoE connections up
to 30 W and ports 17-24 can support UPoE connections up
to 60 W.
For AS4610-54P, ports 1-40 can support PoE connections up
to 30 W and ports 41-48 can support UPoE connections up
to 60 W.
Connect DAC cables to the SFP+/QSFP+ slots. Or first install
SFP+/QSFP+ transceivers and then connect fiber optic
cabling to the transceiver ports.
The following transceivers are supported:
◆
40GBASE-CR4
◆
40GBASE-SR4
◆
10GBASE-CR
◆
10GBASE-SR (ET5402-SR)
◆
1000BASE-SX (ET4201-SX)
◆
1000BASE-LX (ET4201-LX)
As connections are made, check the port status LEDs to be
sure the links are valid:
◆
On/Blinking Green — Port has a data link. Blinking
indicates network activity.
◆
On/Blinking Amber — Port has a data and PoE link.
Blinking indicates network activity.
2
3
1
1
2
3