Quick Start Guide-R02

Quick Start Guide
– 2 –
6. Perform Initial Configuration
At this point you may need to make a few basic switch
configuration changes before connecting to the network.
Connect a PC to the switch console port using the included
console cable.
Configure the PC’s serial port: 115200 bps, 8 characters, no
parity, one stop bit, 8 data bits, and no flow control.
Log in to the command-line interface (CLI) using default
settings: User “admin” with no password.
Note: For information on initial switch configuration, refer
to the Administrator’s Guide.
7. Connect Network Cables
For RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
Connect DAC cables to the SFP+ slots. Or first install
SFP+transceivers and then connect fiber optic cabling to the
transceiver ports.
The following transceivers are supported:
◆
10GBASE-CR (DAC)
◆
10GBASE-SR (ET5402-SR)
◆
1000BASE-SX (ET4201-SX)
◆
1000BASE-LX (ET4201-LX)
◆
1000BASE-T
◆
100BASE-FX
Note: As connections are made, check the port status LEDs
to be sure the links are valid.
3
1
2
1
2
3
2
1
1
2
Hardware Specifications
Chassis Specifications
SIze W x D x H:
440 x 280 x 44 mm (17.32 x 11.02 x 1.73 inches)
Weight 8.5 kg (18.74 lb), with two installed power supply
modules
(no 40G modules)
Temperature Operating: 0° C to 50° C (32° F to 122° F)
Storage: -40° C to 70° C (-40° F to 158° F)
Humidity Operating: 10% to 90% (non-condensing)
Power Specifications
PSU Rating 100-240 VAC, 50/60 Hz, 3.5 A
300 Watts @ 240 V/115 V per unit
Single rail, auto-sensing, hot pluggable
PSU Maximum
Input Current
3.2 A @ 100 VAC
1.7 A @ 240 VAC
PSU DC Output 5 VDC @ 0.5 A
12 VDC @ 25 A
Switch Power
Consumption
145.2 Watts maximum
130 Watts typical
PSU Size W x D x H:
54.5 x 240 x 40 mm (2.15 x 9.45 x 1.57 inches)
Regulatory Compliances
Emissions EN 55022:2010, Class A
EN 61000-3-2:2009, Class A
EN 61000-3-3:2008
FCC Class A
VCCI Class A
CE Mark
Immunity EN 55024:2010
IEC 61000-4-2/3/4/5/6/8/11
Safety UL (CSA 22.2 No 60950-1 & UL60950-1)
CB (IEC 60950-1/EN 60950-1)