Specifications
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Example usage:
To display the current CPU utilization:
DGS-3400:4#show utilization cpu
Command: show utilization cpu
CPU utilization :
--------------------------------------------------------------------------------------------
Five seconds - 15% One minute - 25% Five minutes - 14%
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
clear counters
Purpose Used to clear the Switch’s statistics counters.
Syntax
clear counters {ports<portlist>}
Description This command will clear the counters used by the Switch to compile
statistics.
Parameters
ports <portlist> − Specifies a port or range of ports to be displayed.
The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port 4
− in numerical order. Non-contiguous portlist entries are separated by
a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions Only administrator-level users can issue this command.
Example usage:
To clear the counters:
DGS-3400:4#clear counters ports 1:2-1:9
Command: clear counters ports 1:2-1:9
Success.
DGS-3400:4#
clear log
Purpose Used to clear the Switch’s history log.
Syntax
clear log
Description This command will clear the Switch’s history log.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To clear the log information:
63