Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show packet ports
comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions None.
Example usage:
To display the packets analysis for port 7 of switch 1:
DGS-3400:4#show packet ports 1:7
Command: show packet ports 1:7
Port number :1:7
================================================================
Frame Size/Type Frame Counts Frames/sec
--------------- ---------------------- -----------
64 3275 10
65-127 755 10
128-255 316 1
256-511 145 0
512-1023 15 0
1024-1518 0 0
Unicast RX 152 1
Multicast RX 557 2
Broadcast RX 3686 16
Frame Type Total Total/sec
--------------- ---------------------- -----------
RX Bytes 408973 1657
RX Frames 395 19
TX Bytes 7918 178
TX Frames 111 2
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show error ports
Purpose Used to display the error statistics for a range of ports.
Syntax
show error ports <portlist>
Description This command will display all of the packet error statistics collected
and logged by the Switch for a given port list.
Parameters
<portlist> − Specifies a port or range of ports to be displayed. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions None.
Example usage:
To display the errors of the port 3 of switch 1:
61