Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3450:4#show config current_config
Command: show config current_config
#-------------------------------------------------------------------------------
# DGS-3450 Gigabit Ethernet Switch
# Configuration
#
# Firmware: Build 2.00-B48
# Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# STACK
##Box Prio
##ID Type Exist rity
##------ ------- --------- -------
# 1 DGS-3426P exist 16
# 2 DGS-3426 exist 32
# 3 DGS-3450 exist 32
# 4 Not_Exist no
# 5 Not_Exist no
# 6 Not_Exist no
upload
Purpose Used to upload switch settings or the switch history log to a TFTP.
Syntax
upload [cfg_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>
{<config_id 1-2>} | log_toTFTP [<ipaddr> | <ipv6addr>] <path_filename
64>] | attack_log_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>]
{unit <unit_id 1-12>}]
Description This command is used to upload either the Switch’s current settings or the
Switch’s history log to a TFTP server.
Parameters
cfg_toTFTP − Specifies that the Switch’s current settings will be uploaded
to the TFTP server.
• <ipaddr> − The IPv4 address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
• <ipv6addr> − The IPv6 address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
• <path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be replaced by
the uploaded file from the Switch.
• <config_id 1-2> - Entering this parameter will upload configurations
to be specified, which were saved in NV-RAM to TFTP server.
log_toTFTP − Specifies that the switch history log will be uploaded to the
TFTP server.
• <ipaddr> − The IP address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
• <ipv6addr> − The IPv6 address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
• <path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be replaced by
the uploaded file from the Switch.
attack_log_toTFTP - This command is used to upload a switch attack log to
a TFTP server, such as a spoofing attack.
• <ipaddr> - Enter the IPv4 address of the TFTP server to which to
upload the attack log.
• <ipv6addr> - Enter the IPv6 address of the TFTP server to which to
54