Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
To display the currently configured SNMP hosts on the Switch:
DGS-3400:4#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name/SNMPv3
User Name
--------------- --------------------- ------------------------------
10.48.76.23 V2c private
10.48.74.100 V3 authpriv public
Total Entries: 2
DGS-3400:4#
show snmp v6host
Purpose Used to display the IPv6 recipient of SNMP traps generated by the
Switch’s SNMP agent.
Syntax
show snmp v6host {<ipv6addr>}
Description The show snmp v6host command is used to display the IPv6
addresses and configuration information of remote SNMP managers
that are designated as recipients of SNMP traps that are generated by
the Switch’s SNMP agent.
Parameters
v6host <ipv6addr> − The IPv6 address of a remote SNMP manager
that will receive SNMP traps generated by the Switch’s SNMP agent.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the currently configured IPv6 SNMP hosts on the Switch:
DGS-3400:4#show snmp host
Command: show snmp host
SNMP Host Table
--------------------------------------------------------------------------------------------
Host IPv6 Address : FF::FF
SNMP Version : V3 na/np
CommunityName/SNMPv3 User Name : initial
Total Entries: 1
DGS-3400:4#
enable snmp traps
Purpose Used to enable SNMP trap support.
Syntax
enable snmp traps
Description The enable snmp traps command is used to enable SNMP trap
support on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable SNMP trap support on the Switch:
44