Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
clear port_security_entry
specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in
numerical order. Non-contiguous portlist entries are separated by a comma.
(ex: 1:1-1:3,1:7-1:9)
Restrictions Only administrator-level users can issue this command.
Example usage:
To clear a port security entry by port:
DGS-3400:4# clear port_security_entry port 1:6
Command: clear port_security_entry port 1:6
Success.
DGS-3400:4#
show port_security
Purpose Used to display the current port security configuration.
Syntax
show port_security {ports <portlist>}
Description This command is used to display port security information of the
Switch’s ports. The information displayed includes port security,
admin state, maximum number of learning address and lock mode.
Parameters
<portlist> − Specifies a port or range of ports to be viewed. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning and
end of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions None.
Example usage:
To display the port security configuration:
DGS-3400:4#show port_security ports 1:1-1:5
Command: show port_security ports 1:1-1:5
Port Admin State Max. Learning Addr. Lock Address Mode
---- ----------- ------------------- -----------------
1 Disabled 1 DeleteOnReset
2 Disabled 1 DeleteOnReset
3 Disabled 1 DeleteOnReset
4 Disabled 1 DeleteOnReset
5 Disabled 1 DeleteOnReset
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
27