Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4# config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================
DGS-3400 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.B46
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
--------------------------------------------------------------------------------
show greeting_message
Used to view the currently configured greeting message configured
on the Switch.
Syntax
show greeting_message
Description This command is used to view the currently configured greeting
message on the Switch.
Parameters None.
Restrictions None.
Purpose
Example usage:
To view the currently configured greeting message:
Command: show greeting_message
DGS-3400:4#show greeting_message
=========================================================================
DGS-3400 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.B48
Copyright(C) 2004-2005 D-Link Corporation. All rights reserved.
=========================================================================
DGS-3400:4#
284
config command prompt
Purpose Used to Configure the command prompt.
Syntax
config command_prompt [<string 16> | username | default]
Description Administrator level users can use this command to change the
command prompt.
Parameters string 16 - The command prompt can be changed by entering a
new name of no more than 16 characters.
username - The command prompt will be changed to the login
username.
default – The command prompt will reset to factory default