Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show poe ports
Purpose
show poe ports {<portlist>}
Description Display the settings, actual values and port configuration of the
whole PoE system.
Parameters ports – Choosing this parameter will display the settings for PoE on
a port-by-port basis.
Restrictions None.
Used to display the setting and actual values of the whole PoE
system.
Syntax
• portlist – Enter a port or range of ports to be displayed for
their PoE settings. The port list is specified by listing the
lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example,
1:3 specifies switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
Non-contiguous portlist entries are separated by a comma.
(ex: 1:1-1:3,1:7-1:9)
Example usage:
To display the power settings for the switch’s ports
DGS-3400:4#show poe ports
Command: show poe ports
Port State Priority Power Limit(mW)
Class Power(mW) Voltage(decivolt) Current (mA)
Status
=================================================
1:1 Enabled Critical 12000(User-defined)
0 0 0 0
OFF : Non-standard PD connected
1:2 Enabled Critical 12000(User-defined)
0 0 0 0
OFF : Interim state during line detection
1:3 Enabled Critical 12000(User-defined)
0 0 0 0
OFF : Interim state during line detection
1:4 Enabled Low 15400(User-defined)
0 0 0 0
OFF : Interim state during line detection
0 0 0 0
1:6 Enabled Low 15400(User-defined)
0 0 0 0
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
1:5 Enabled Low 15400(User-defined)
OFF : Interim state during line detection
OFF : Interim state during line detection
show poe system
278
Purpose Used to display the setting and actual values of the whole PoE
system.
Syntax
show poe system {units <unitlist>}
Description This command will display the system settings for PoE, such as
it h
li it ti i i bl d th