Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config ssh user
publickey – This parameter should be chosen to use the publickey
on a SSH server for authentication.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the SSH user:
DGS-3400:4# config ssh user Trinity authmode Password
Command: config ssh user Trinity authmode Password
Enter a case sensitive new password: *******
Enter the new password again for conformation:*******
Success.
DGS-3400:4#
show ssh user authmode
Purpose Used to display the SSH user setting.
Syntax
show ssh user authmode
Description This command allows users to display the current SSH user setting.
Parameters None.
Restrictions None.
Example usage:
To display the SSH user:
DGS-3400:4#show ssh user authmode
Command: show ssh user authmode
Current Accounts:
UserName Authentication Host Name Host IP
-------------- --------------------- ----------------- ---------
Trinity Hostbased 12334 10.45.25.8
DGS-3400:4#
Note: To configure the SSH user, the administrator must create a user account on the
Switch. For information concerning configuring a user account, please see the section of
this manual entitled Basic Switch Commands and then the command, create account
user.
config ssh algorithm
Purpose Used to configure the SSH algorithm.
Syntax
config ssh algorithm [3DES | AES128 | AES192 | AES256 | arcfour |
blowfish | cast128 | twofish128 | twofish192 | twofish256 | MD5 |
SHA1 | RSA | DSA] [enable | disable]
Description This command allows users to configure the desired type of SSH
algorithm used for authentication encryption.
Parameters 3DES – This parameter will enable or disable the Triple_Data
EtiStdd t
ilith
255