Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config authen_enable
If no verification is found, the Switch will send an authentication request to the second
TACACS host in the server group and so on, until the list is exhausted. At that point, the
Switch will restart the same sequence with the following protocol listed, xtacacs. If no
authentication takes place using the xtacacs list, the local_enable password set in the Switch
is used to authenticate the user.
Successful authentication using any of these methods will give the user an “Admin” level
privilege.
Parameters
 none – Adding this parameter will require no authentication to access the
administration level privileges on the Switch.
Parameters
method_list_name – Enter a previously implemented method list name defined by the user
(create authen_enable). The user may add one, or a combination of up to four (4) of the
following authentication methods to this method list:
default – The default method list for administration rights authentication, as defined by the
user. The user may choose one or a combination of up to four (4) of the following
authentication methods:
 tacacs – Adding this parameter will require the user to be authenticated using the
TACACS protocol from the remote TACACS server hosts of the TACACS server
group list.
 xtacacs – Adding this parameter will require the user to be authenticated using the
XTACACS protocol from the remote XTACACS server hosts of the XTACACS
server group list.
 tacacs+ – Adding this parameter will require the user to be authenticated using the
TACACS+ protocol from the remote TACACS+ server hosts of the TACACS+
server group list.
 radius – Adding this parameter will require the user to be authenticated using the
RADIUS protocol from the remote RADIUS server hosts of the RADIUS server
group list.
 server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
Switch.
 local_enable - Adding this parameter will require the user to be authenticated using
the local user account database on the Switch.
 none – Adding this parameter will require no authentication to access the Switch.
 tacacs – Adding this parameter will require the user to be authenticated using the
TACACS protocol from a remote TACACS server.
 xtacacs – Adding this parameter will require the user to be authenticated using the
XTACACS protocol from a remote XTACACS server.
 tacacs+ – Adding this parameter will require the user to be authenticated using the
TACACS+ protocol from a remote TACACS+ server.
 radius - Adding this parameter will require the user to be authenticated using the
RADIUS protocol from a remote RADIUS server.
 server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
Switch.
 local_enable - Adding this parameter will require the user to be authenticated using
the local user account database on the Switch. The local enable password of the
device can be configured using the “config admin local_password” command.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the user defined method list “Permit” with authentication methods TACACS, XTACACS and local, in that
order.
238