Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
delete iproute ipv6
Description This command will delete an existing static IPv6 entry from the Switch’s
IP routing table.
Parameters
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that
is the destination of the route. Specify the address and mask information
using the format as ipv6address / prefix_length (ipv6address is
hexadecimal number, prefix length is decimal number, for example
1234::5D7F/32).
<ipv6addr> − IPv6 address for the next hop router.
all − This will delete all IPv6 static entries for the destination and next
hop.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a static IPv6 entry from the routing table:
DGS-3400:4# delete iproute ipv6 1234::5D7F/32 2D30::AC21
Command: delete iproute ipv6 1234::5D7F/32 2D30::AC21
Success.
DGS-3400:4#
show iproute ipv6
Purpose Used to display the Switch’s current static IPv6 routing table or a
specified IPv6 address.
Syntax
show iproute ipv6 {<ipv6networkaddr>}
Description This command will display the Switch’s current static IPv6 routing table
or a specific IPv6 entry.
Parameters
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that
is the destination of the route. Specify the address and mask
information using the format as ipv6address / prefix_length
(ipv6address is hexadecimal number, prefix length is decimal number,
for example 1234::5D7F/32).
Restrictions None.
Example usage:
To display the static IPv6 entries in the routing table:
DGS-3400:4# show iproute ipv6
Command: show iproute ipv6
Routing Table
IPV6 Address/Netmask Gateway Cost Protocol
-------------------------------- ------------------------ -------- --------
1234::/32 2D30::AC21 1 Static
Total Entries: 1
DGS-3400:4#
225
create iproute ipv6 default