Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show iproute
Restrictions None.
Example usage:
To display the contents of the IP routing table:
DGS-3400:4#show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Cost Protocol
------------------ -------------- ------------ ------- --------
10.0.0.0/8 0.0.0.0 System 1 Local
Total Entries : 1
DGS-3400:4#
create iproute ipv6
Purpose Used to create Ipv6 route entries to the Switch’s IP routing table.
Syntax
create iproute ipv6 [<ipif_name 12> <ipv6networkaddr> <ipv6addr>
{<metric 1-65535>} | <ipv6networkaddr> <ipv6addr> {<metric 1-65535>}]
Description This command is used to create a primary and backup IP route entry to the
Switch’s IP routing table.
Parameters <ipif_name 12>- Enter the IP interface name for which to create a static
route. Configuring this command without this parameter will set the static
route for the System IP interface.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that is
the destination of the route. Specify the address and mask information using
the format as ipv6address / prefix_length (ipv6address is hexadecimal
number, prefix length is decimal number, for example 1234::5D7F/32).
<ipv6addr> − IPv6 address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP address
above. The default setting is 1.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add a single static IPv6 entry in IPv6 format:
DGS-3400:4# create iproute ipv6 1234::5D7F/32 2D30::AC21
Command: create iproute ipv6 1234::5D7F/32 2D30::AC21
Success.
DGS-3400:4#
delete iproute ipv6
Purpose Used to delete an static IPv6 route entry from the Switch’s IP routing
table.
Syntax
delete iproute ipv6 {<ipv6networkaddr> <ipv6addr> | all}
224