Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
To delete an entry of IP address 10.48.74.121.125 from the ARP table:
DGS-3400:4#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DGS-3400:4#
config arp_aging time
Purpose Used to configure the age-out timer for ARP table entries on the
Switch.
Syntax
config arp_aging time <value 0-65535>
Description This command sets the maximum amount of time, in minutes, that
an ARP entry can remain in the Switch’s ARP table, without being
accessed, before it is dropped from the table.
Parameters
time <value 0-65535> − The ARP age-out time, in minutes. The
value may be set in the range of 0-65535 minutes with a default
setting of 20 minutes.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure ARP aging time:
DGS-3400:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3400:4#
show arpentry
Purpose Used to display the ARP table.
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static}
Description This command is used to display the current contents of the Switch’s ARP
table.
ipif <ipif_name 12> − The name of the IP interface the end node or station
for which the ARP table entry was made, resides on.
ipaddress <ipaddr> − The network address corresponding to the IP
interface name above.
Restrictions None.
Syntax
Parameters
static − Displays the static entries in the ARP table.
Example usage:
To display the ARP table:
218