Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show access_profile
Parameters
profile_id <value 1-6> − Enter an integer between 1 and 6 that is used to identify
the access profile that will be viewed with this command. This value is assigned
to the access profile when it is created with the create access_profile
command.
Entering this command without the profile_id parameter will command the
Switch to display all access profile entries.
Restrictions None.
Example usage:
To display all of the currently configured access profiles on the Switch:
DGS-3400:4#show access_profile
Command: show access_profile
Access Profile Table
Access Profile ID: 1 TYPE : Ethernet
======================================================================
MASK Option :
VLAN 802.1p
----------- ------
Access ID : 3 Mode: Permit(replaced) priority: 1 RX Rate(64Kbps): no_limit
Ports: 1:1
----------- ------
Trinity 1
======================================================================
Access Profile ID: 2 TYPE : IP
======================================================================
MASK Option :
Protocol ID
--------------------
Access ID : 2 Mode: Deny
Ports: 1:2
--------------------
2
======================================================================
Access Profile ID: 3 TYPE : Packet Content
======================================================================
MASK Option :
Offset 0-15 : 0xFFFFFFFF 0xFFFFFFFF 0xFFFFFFFF 0xFFFFFFFF
Offset 16-31 : 0x0000FFFF 0xFFFF0000 0x0000000F 0x0F000000
Access ID : 1 Mode: Deny
Ports: 1:1
Offset 0-15 : 0x11111111 0x11111111 0x11111111 0x11111111
Offset 16-31 : 0x00001111 0x11110000 0x00000001 0x01000000
======================================================================
Total Entries: 3
DGS-3400:4#
194