Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#config access_profile profile_id 2 add access_id 2 ip protocol_id 2 port 1:2 deny
Command: config access_profile profile_id 2 add access_id 2 ip protocol_id 2 port 1:2 deny
Success.
DGS-3400:4#
create access_profile (ipv6)
Purpose Used to create an access profile on the Switch by examining the IPv6 part of
the packet header. Masks can be entered that will be combined with the values
the Switch finds in the specified frame header fields. Specific values for the
rules are entered using the config access_profile command, below.
Syntax
create access_profile profile_id <value 1-6> ipv6 {[{class | flowlabel |
source_ipv6_mask <ipv6mask> | destination_ipv6_mask <ipv6mask>]}]
This command is used to identify various parts of IPv6 packets that enter the
Switch so they can be either forwarded or filtered.
profile_id <value 1-6> - Specifies an index number between 1 and 6 that will
identify the access profile being created with this command.
ipv6 – Denotes that IPv6 packets will be examined by the Switch for forwarding
or filtering based on the rules configured in the config access_profile
command for IPv6. IPv6 packets may be identified by the following:
Restrictions Only administrator-level users can issue this command.
Description
Parameters
• class – Entering this parameter will instruct the Switch to examine the
class field of the IPv6 header. This class field is a part of the packet
header that is similar to the Type of Service (ToS) or Precedence bits
field in IPv4.
• flowlabel – Entering this parameter will instruct the Switch to examine the
flow label field of the IPv6 header. This flow label field is used by a source
to label sequences of packets such as non-default quality of service or
real time service packets.
• source_ipv6_mask <ipv6mask> - Specifies an IP address mask for the
source IPv6 address.
• destination_ipv6_mask <ipv6mask> - Specifies an IP address mask for
the destination IPv6 address.
Example usage:
To create an access profile based on IPv6 classification:
DGS-3400:4#create access_profile profile_id 4 ipv6 class flowlabel
Command: create access_profile profile_id 4 ipv6 class flowlabel
Success.
DGS-3400:4#
config access_profile profile_id (ipv6)
Purpose Used to configure the IPv6 access profile on the Switch and to define specific values for
the rules that will be used to by the Switch to determine if a given packet should be
forwarded or filtered. Masks entered using the create access_profile command will be
combined, using a logical AND operational method, with the values the Switch finds in
the specified frame header fields.
Syntax
191
config access_profile profile_id <value 1-6> add access_id [auto_assign | <value
1-128>] ipv6 {class <value 0-255> | flowlabel <hex 0x0-0xfffff> | source_ipv6