Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show auth_session_statistics ports 1:16
Command: show auth_session_statistics ports 1:16
Port number : 1:16
SessionOctetsRx 0
SessionOctetsTx 0
SessionFramesTx 0
SessionAuthenticMethod Remote Authentication Server
SessionTime 0
SessionUserName Trinity
SessionFramesRx 0
SessionId
SessionTerminateCause SupplicantLogoff
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_statistics
Purpose Used to display the current authentication statistics.
Syntax
show auth_statistics {ports <portlist> | all]}
Description The show auth_statistics command is used to display the current
authentication statistics of the Switch on a per port basis.
Parameters
ports <portlist> − Specifies a range of ports. The port list is specified by
listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated by
a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch
1, port 3 and switch 2, port 4 − in numerical order. Non-contiguous
portlist entries are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
To display the current authentication statistics for port 1:16:
DGS-3400:4#show auth_statistics ports 1:16
Command: show auth_statistics ports 1:16
Port number : 1:16
EapolFramesRx 0
EapolFramesTx 0
EapolStartFramesRx 0
EapolReqIdFramesTx 0
EapolLogoffFramesRx 0
EapolReqFramesTx 0
EapolRespIdFramesRx 0
EapolRespFramesRx 0
InvalidEapolFramesRx 0
EapLengthErrorFramesRx 0
LastEapolFrameVersion 0
LastEapolFrameSource 00-00-00-00-00-00
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
181