Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
To configure the RADIUS settings:
DGS-3400:4#config radius 1 10.48.74.121 key dlink default
Command: config radius 1 10.48.74.121 key dlink default
Success.
DGS-3400:4#
show radius
Purpose Used to display the current RADIUS configurations on the Switch.
show radius
The show radius command is used to display the current RADIUS
configurations on the Switch.
Parameters None.
Restrictions None.
Syntax
Description
Example usage:
To display RADIUS settings on the Switch:
DGS-3400:4#show radius
Command: show radius
Idx IP Address Auth-Port Acct-Port Status Key
No. No.
----- ------------------ --------- --------- ----------- ------------
1 10.1.1.1 1812 1813 Active switch
2 20.1.1.1 1800 1813 Active dgs3426
3 30.1.1.1 1812 1813 Active dlink
Total Entries : 3
DGS-3400:4#
create 802.1x user
Purpose Used to create a new 802.1x user.
Syntax
create 802.1x user <username 15>
Description The create 802.1x user command is used to create new 802.1x
users.
Parameters
<username 15> − A username of up to 15 alphanumeric characters in
length.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create an 802.1x user:
176