Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config 802.1x reauth
can then be specified.
mac_based − This instructs the Switch to re-authorize 802.1x functions
based only on the MAC address. MAC addresses approved for re-
authorization can then be specified.
ports <portlist> − Specifies a port or range of ports to be re-authorized.
The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port 4 −
in numerical order.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Enter the MAC address to be re-
authorized.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x reauthentication for ports 1:1-1:18:
DGS-3400:4#config 802.1x reauth port_based ports 1:1-1:18
Command: config 802.1x reauth port_based ports 1:1-1:18
Success.
DGS-3400:4#
config radius add
Used to configure the settings the Switch will use to communicate with a
RADIUS server.
Syntax
config radius add <server_index 1-3> <server_ip> key <passwd 32>
[default | {auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
Description The config radius add command is used to configure the settings the
Switch will use to communicate with a RADIUS server.
Parameters
<server_index 1-3> − Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between
the Switch and the Radius server.
<passwd 32> − The shared-secret key used by the RADIUS server and
the Switch. Up to 32 characters can be used.
default − Uses the default UDP port number in both the “auth_port” and
“acct_port” settings.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Restrictions
Purpose
Only administrator-level users can issue this command.
Example usage:
174