Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config 802.1x auth_mode
Purpose Used to configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x auth_mode command is used to enable either the port-
based or MAC-based 802.1x authentication feature on the Switch.
Parameters
[port_based | mac_based] − The Switch allows users to authenticate 802.1x
by either port or MAC address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication by MAC address:
DGS-3400:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DGS-3400:4#
config 802.1x capability ports
Purpose Used to configure the 802.1x capability of a range of ports on the
Switch.
Syntax
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
Description The config 802.1x capability ports command has four capabilities
that can be set for each port. Authenticator, Supplicant, Authenticator
and Supplicant, and None.
Parameters
<portlist> − Specifies a port or range of ports to be configured. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
all − Specifies all of the ports on the Switch.
authenticator − A user must pass the authentication process to gain
access to the network.
none − The port is not controlled by the 802.1x functions.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x capability on ports 1-10 of module 1:
DGS-3400:4#config 802.1x capability ports 1:1 – 1:10 authenticator
Command: config 802.1x capability ports 1:1 – 1:10 authenticator
Success.
DGS-3400:4#
171