Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
delete limited multicast address
Purpose Used to delete Limited IP multicast address range.
Syntax
delete limited multicast address [all | <portlist>]
Description The delete limited multicast address command allows the user to
delete all multicast address ranges or a selected range based on
which port or ports the range has been assigned.
Parameters all - Allows the user to delete all limited multicast addresses that
have been configured on the Switch.
<portlist> - Allows the user to delete only those multicast address
ranges that have been assigned to a particular port or range of ports.
The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete the limited multicast address on ports 1-3:
DGS-3400:4#delete limited multicast address 1:1-1:3
Command: delete limited multicast address 1:1-1:3
Success.
DGS-3400:4#
show limited multicast address
Purpose Used to show per-port Limited IP multicast address range.
Syntax
show limited multicast address {<portlist>}
Description The show limited multicast address command allows the user to
show multicast address range by ports.
Parameters <portlist> - A port or range of ports on which the limited multicast
address range to be shown has been assigned. The port list is
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order. Non-contiguous portlist entries are
separated by a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions None.
Example usage:
To show the limited multicast address on ports 1-3 of module 1:
164