Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Command Parameters
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports [ portlist | all]} |
mode [arp | acl]}
enable address_binding acl_mode
enable address_binding trap_log
disable address_binding trap_log
disable address_binding acl_mode
Each command is listed, in detail, in the following sections.
create address_binding ip_mac ipaddress
Purpose Used to create an IP-MAC Binding entry.
Syntax
create address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all] | mode {arp | acl]}
Description This command will create an IP-MAC Binding entry.
Parameters <ipaddr> The IP address of the device where the IP-MAC binding is
made.
<macaddr> The MAC address of the device where the IP-MAC binding
is made.
<portlist> - Specifies a port or range of ports to be configured for
address binding. The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The beginning and
end of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4.
1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order. Non-contiguous portlist entries are
separated by a comma. (ex: 1:1-1:3,1:7-1:9)
all – Specifies that all ports on the switch will be configured for address
binding.
mode – The user may set the mode for this IP-MAC binding settings by
choosing one of the following:
Restrictions Only administrator-level users can issue this command.
• arp - Choosing this selection will set a normal IP-MAC Binding
entry for the IP address and MAC address entered.
• acl - Choosing this entry will allow only packets from the source
IP-MAC binding entry created here. All other packets with a
different IP address will be discarded by the Switch. This mode
can only be used if the ACL Mode has been enabled in the IP-
MAC Binding Ports window as seen previously.
Example usage:
To create address binding on the Switch:
DGS-3400:4#create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Success.
DGS-3400:4#
To create address binding on the Switch for ACL mode:
130