Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
NOTE: When using LACP or static type link aggregation, be sure that both sides of
the connection are identical in speed and duplex settings.
delete link_aggregation group_id
Purpose Used to delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id <value 1-32>
Description This command is used to delete a previously configured link
aggregation group.
Parameters
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DGS-3400:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DGS-3400:4#
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-32> {master_port <port>
| ports <portlist> | state [enable | disable]
Description This command allows configuration of a link aggregation group that was
created with the create link_aggregation command above. The DGS-
3400 supports link aggregation cross box which specifies that link
aggregation groups may be spread over multiple switches in the
switching stack. Up to eight ports can be set per link aggregation group.
Parameters
group _id <value 32> − Specifies the group ID. The Switch allows up to
32 link aggregation groups to be configured. The group number
identifies each of the groups.
master_port <port> − Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of the
ports in a link aggregation group will share the port configuration with
the master port. The port is specified by listing the switch number and
the port number on that switch, separated by a colon. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4.
ports <portlist> − Specifies a range of ports that will belong to the link
aggregation group. The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The beginning and
end of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4.
1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order. Non-contiguous portlist entries are
separated by a comma. (ex: 1:1-1:3,1:7-1:9) Ports may be listed in only
one port aggregation group, that is, link aggregation groups may not
125