Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show vlan
Purpose Used to display the current VLAN configuration on the Switch
Syntax
show vlan {<vlan_name 32>}
Description This command displays summary information about each VLAN
including the VLAN ID, VLAN name, the Tagging/Untagging status,
and the Member/Non-member/Forbidden status of each port that is
a member of the VLAN.
Parameters
<vlan_name 32> − The VLAN name of the VLAN for which to
display a summary of settings.
Restrictions None.
Example usage:
To display the Switch’s current VLAN settings:
DGS-3400:4#show vlan
Command: show vlan
VID : 1 VLAN Name : default
VLAN TYPE : 1QVLAN Protocol ID :
UserDefinedPid : Advertisement : Enabled
Encap :
Member ports : 1:1-1:2,1:6-1:24,2:1-2:24
Static ports : 1:1-1:2,1:6-1:24,2:1-2:24
Current Tagged ports :
Current Untagged ports : 1:1-1:2,1:6-1:24,2:1-2:24
Static Tagged ports :
Static Untagged ports : 1:1-1:2,1:6-1:24,2:1-2:24
Forbidden ports :
Static ports : 1:3-1:5
Static Tagged ports : 1:3-1:5
VID : 2 VLAN Name : Trinity
VLAN TYPE : PROTOCOL Protocol ID : ipV6
UserDefinedPid : Advertisement : Disabled
Encap :
Member ports : 1:3-1:5
Current Tagged ports : 1:3-1:5
Current Untagged ports :
Static Untagged ports :
Forbidden ports :
Total Entries: 2
DGS-3400:4#
show gvrp
Purpose Used to display the GVRP status for a port list on the Switch.
Syntax
show gvrp {<portlist>}
Description This command displays the GVRP status for a port list on the Switch.
Parameters
<portlist> − Specifies a port or range of ports for which the GVRP
status is to be displayed. The port list is specified by listing the
lowest switch number and the beginning port number on that switch,
separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated
118