Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
create vlan
protocol.







protocol-decLAT - Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent with this
protocol. This packet header information is defined by the Digital Equipment
Corporation (DEC) Local Area Transport (LAT) protocol.
protocol–sna802dot2 - Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is concurrent with
this protocol. This packet header information is defined by the Systems
Network Architecture (SNA) 802.2 Protocol.
protocol–snaEthernet2 - Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is concurrent with
this protocol. This packet header information is defined by the Systems
Network Architecture (SNA) Ethernet II Protocol.
protocol-netBios - Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent with this
protocol. This packet header information is defined by the NetBIOS Protocol.
protocol-xns - Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent with this
protocol. This packet header information is defined by the Xerox Network
Systems (XNS) Protocol.
protocol-vines - Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent with this
protocol. This packet header information is defined by the Banyan Virtual
Integrated Network Service (VINES) Protocol.
protocol-ipV6 - Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent with this
protocol. This packet header information is defined by the Internet Protocol
Version 6 (IPv6) Protocol.
protocol–userDefined - Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent with this
protocol defined by the user. This packet header information is defined by
entering the following information:
Restrictions Each VLAN name can be up to 32 characters. If the VLAN is not given a tag, it will
be a port-based VLAN. Only administrator-level users can issue this command.



<hex 0x0-0xffff> - Specifies that the VLAN will only accept packets
with this hexadecimal protocol value in the packet header.
encap [ethernet | llc | snap | all] – Specifies that the Switch will examine
the octet of the packet header referring to one of the protocols listed
(Ethernet, LLC or SNAP), looking for a match of the hexadecimal value
previously entered . all will instruct the Switch to examine the total packet
header. After a match is found, the Switch will forward the packet to this
VLAN.
protocol-rarp - Using this parameter will instruct the Switch to forward
packets to this VLAN if the tag in the packet header is concurrent with this
protocol. This packet header information is defined by the Reverse Address
Resolution (RARP) Protocol.
Example usage:
To create a protocol VLAN:
DGS-3400:4#create vlan v5 tag 2 protocol-ipxSnap
Command: create vlan v5 tag 2 protocol-ipxSnap
Success.
DGS-3400:4#
Example usage:
114