Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config bandwidth_control
Purpose Used to configure bandwidth control on a port-by-port basis.
Syntax
config bandwidth_control <portlist> {rx_rate [no_limit | <value
1-156249>] | tx_rate [no_limit | <value 1-156249>]}
Description The config bandwidth_control command is used to configure
bandwidth on a port-by-port basis.
Parameters
<portlist> − Specifies a port or range of ports to be configured. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
rx_rate − Specifies that one of the parameters below (no_limit or
<value 1-156249>) will be applied to the rate at which the above
specified ports will be allowed to receive packets
 no_limit − Specifies that there will be no limit on the rate of
packets received by the above specified ports.
 <value 1-156249> − Specifies the receiving packet limit,
where each value entered here represents 64Kbps. (ex. A
value of 2 would be 128kbps)
tx_rate − Specifies that one of the parameters below (no_limit or
<value 1-156249>) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
 no_limit − Specifies that there will be no limit on the rate of
packets transmitted by the above specified ports.
 <value 1-156249> − Specifies the transferring packet limit,
where each value entered here represents 64Kbps. (ex. A
value of 2 would be 128kbps)
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure bandwidth control:
DGS-3400:4#config bandwidth_control 1:1-1:8 rx_rate 64 tx_rate 64
Command: config bandwidth_control 1:1-1:8 rx_rate 64 tx_rate 64
Success.
DGS-3400:4#
show bandwidth_control
Purpose Used to display the bandwidth control table.
Syntax
show bandwidth_control {<portlist>}
Description The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a port or range of ports to be viewed. The port
list is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
100