User`s manual

3
● Do not insert sharp objects or spill liquid into the LCD monitor through cabinet slots.
It may cause accidental fire, electric shock or failure.
● Disconnect the power plug from the AC outlet if you are not using it for an indefinite
period of time.
● Do not attempt to service this product yourself, as opening or removing covers may
expose you to dangerous voltage points or other risks.
● Do not touch the screen directly with your fingers. You may damage the screen, and
the grease from your skin is difficult to remove.
● Do not apply pressure to screen. The LCD is very delicate.
Power
● Use the type of power indicated on the rating label.
Plug
● Do not remove any of the prongs of the m
onitors ,three-pronged power plug.
● Disconnect the power plug from the AC outlet under
the following conditions:
● If you are not using it for an indefinite period time.
● When the power cord or plug is damaged or frayed.
● If the product does not operate normally when the operating instructions are
followed.
● If the product has been dropped or the cabinet has been damaged.
● If the product exhibits a distinct change in performance, indicating need for service.
Power and extension cord
● Do not allow anything to rest on the power cord.
● Do not locate this product where persons will walk on the cord.
● Use the proper power cord with correct attachment plug type. If the power source is
120V AC, use a power cord that has UL and C-UL approvals. If the power source is
a 240V AC supply, use the tandem (T blade) type attachment plug with ground
conductor power cord that meets the respective European country s safety regulations,
such as VDE for Germany.
● Do not overload wall outlets or power cords. Ensure that the total of all units
plugged into the wall outlet does not exceed 10 amperes.
● Ensure that the total ampere ratings on all units plugged into the extension
cord is not
above the cords rating.
● If the power supply cord, which came with your monitor, is to be connected to the PC
instead of the wall outlet, this equipment is to be used with UL/TUV approved
computers with receptacle rated 100~240VAC,50/60Hz,1.0A(minimum).
Environment
● Place the monitor on a flat and level surface.
● Place the monitor in a well-ventilated place.
● Keep the monitor away from: Overly hot, cold or humid places, places directly under
sunlight, dusty surroundings, equipment that generates strong magnetic field.