Manualshelf

User`s manual

ManualsBrandsEdge10 ManualsNAS & storage servers2TB DAS400
12345678910
3 MODE SETTING
3.1 INTRODUCTION
The DAS400 storage appliance is an easy-to-use storage that provides variety of modes; you can simplely set
up the mode by hardware DIP switch on the back panel. The mode shows as seen below.
3.2 DISK DRIVE MODE
Please read the notics carefully before you change disk drive mode. The following notices are intended to remind
you to operate the product correctly. Please read and ensure that you understand them before you proceed to
change disk drive mode.
a
Data will be lost, when the mode change.
a
Turn off the power of storage device before change mode.
a
2TB capacity is the limitation for each disk volume.
Switch the DIP 1 to setup the disk drive mode on the back panel. Please refer to the diagrams.
DAS400
User’s
Manual
Ver.
071018
9