Specifications

Electrified Exit Devices
ED5000.35
ED5000 Series Pushpad Exit Devices
Options
Bolt Position Monitor M91:
SPDT (Single Pole Double Throw) switch
that monitors the position of the latchbolt
or vertical rods. To order, specify M91.
Outside Trim Monitor M93:
Used when outside trim is desired to be
used with an external door position
switch (by others) input. This switch will
allow Bypass (disarms device) when the
trim is used for ingress. The device
requires setting after entry by means of
the keyswitch on the device or a remote
switch. To order, specify M93.
Note: If an external DPS is not used,
standard trim will allow entry without
affecting the device in an armed mode.
The device will only be affected when the
touchbar is depressed.
Mortise Electric Trim Control SAF/SEC:
The mortise delayed egress exit device can
be ordered with Fail Safe or Fail Secure
outside trim operation. In a fire condition
the Fail Safe trim will release for entry.
When access control is used the Fail Secure
trim allows entry by means of a remote card
reader, keyswitch, pushbutton, etc. To
order, specify SAF or SEC.
Note: The trim will open the door
without affecting the device in an armed
mode if a door position switch (by others)
is not used.
30-Second Delay M88:
Device released after 30 seconds. The
device will provide visual and audible
indication that the delayed egress cycle has
been activated. After the device has been
released, the siren changes to a steady tone
which continues until reset by keyswitch or
remote inputs on the device. Required
signage must indicate 30 seconds for
release. To order, specify M88.
Note: 30 seconds may be accepted by
local jurisdiction.
BOCA 15-Second Delay M89:
BOCA 30-Second Delay M90:
Upon pressing the touchpad for 3 seconds
or more, the device will sound an audible
beeping tone and release for egress after a
total of 15 or 30 seconds, sounding the
alarm. When the door is re-secured, the
device will automatically rearm after 30
seconds. A door position switch (by
others) is required for this option.
Required signage must indicate 15 or 30
seconds for release. To order, specify M89
for BOCA 15 seconds or M90 for BOCA
30 seconds.
Note: BOCA option is not suitable for
installations in accordance with NFPA 101.
Required Accessories
Power Supply:
A regulated and filtered power supply
with a Fire Alarm interface is required.
1 Amp minimum @ 24VDC per device.
Special options will require more
amperage. Consult factory.
To order, specify:
• MPS 10 – 1 Amp @ 24VDC power
supply (controls 1 “D” device)
• MPS 15 – 1.5 Amp @ 24VDC power
supply (controls 2 “D”s or 1 “D” with
SAF or SEC options)
Power Transfer:
Allows the power to make the transition
from frame to door without pinching or
removal of insulation. Optional power
transfer: EPTL – concealed transfer for
up to and over 120° swing doors. To
order specify Part No. 704F28. Consult
Folger Adam
®
catalog for additional
recommended power supplies and
accessories.
Trims
Utilizes heavy-duty and utility trims. See
Trims and Functions, pages 20-23 and 28-31.
Cylinders
Utilizes a 1-1/8" mortise cylinder.
Cylinder not included unless specified.
See Quick Codes, page 50.
Warranty
Exit devices and heavy-duty trim carry a
five-year limited warranty. Electronic
components and utility trim carry a one-
year limited warranty.
Delayed Egress Exit Device
EPTL
Power Transfer