Specifications

Steps 13-14
13) Plug the battery into the
speed controller. Next, insert
the connected wires into the
front opening of the cabin
inside the battery bay. (Make
sure the wires are clear of the
battery bay so that the battery
can be pushed in fully.
14) Now slide the battery in
securely and close the cover
with both tabs.
Setting up Controls:
Setting up your transmitter controls properly is the key to
having full control over Edge 540T.
Follow these simple steps:
1) Turn on transmitter
2) Plug in flight battery into aircraft.
3) Set all trim tabs on Radio to the neutral (middle) position.
4) Observe all flight surfaces and confirm that they are all in
the neutral positions. If they are not, unscrew control arm off
the servo controlling that specific function and re-place control
arm on servo until neutral position is obtained. The goal is to
make sure that control throw is near equal for each direction of
input.
5) For maximum control throw the attach the plastic clevis to
the inner most hole on the control horn, and the connect the
metal pushrod to the inner most hole on the servo arm. If doing
this makes the plane too reactive for your skill level then back
off one hole or two hole positions accordingly.
- 7 -