Owner manual

SQUARE GLASS SHADE
1
1
SPRING CLIP
2
D
THUMB NUT
THREADED
STUD
ELECTRICAL
BOX
CEILING
E
Install the Lamp & Glass Shade
LAMP
1
SOCKET
1
5
6
5: Place all wire and wire nuts connections inside electrical box.
6: Align and push the canopy holes onto threaded studs and
tighten the thumb nuts completely to secure the canopy in
place.
1: Place one end of the lamp onto one socket pin, while
pushing the lamp against that socket pin slide the other end
onto the other socket pin.
CAUTION:
To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
NOTE: Use only fingers and a soft cloth to install the lamp.
Use MAX 180 Watt Type T4/RSC 118mm, Double
End Krypton/Xenon Lamp with the Vanilla Sky Square
18 and 24.
Use MAX 100 Watt Type T3-78mm, Double
End Halogen Lamp with the Vanilla Sky Square 14.
2: Place the two adjacent edges of the square glass shade into
two adjacent spring clips. Slightly push the glass shade
against these two spring clips and simultaneously slide the
other two edges into the other two spring clips. Make sure
all four edges of the glass shade sit properly into four
spring clips.
F
SQUARE GLASS SHADE
2
2
SPRING CLIP
2
1: While holding the glass shade unhook one spring clip at a
time until the glass shade is free.
2: Remove the old lamp and then follow "Install the Lamp &
Glass Shade" steps to complete lamp replacement.
Replace the Lamp
G
2