Owner manual

SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is ceiling mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard incandescent
dimmer.
Installation Instructions for Vanilla Sky Square 14, 18, & 24
904-VSKY-SQ-H1-02
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
Install the Fixture
1: R
detach the mounting crossbar from the fixture housing.
emove the two thumb nuts from the threaded studs and
2: Mount the universal crossbar to the electrical box holes with
the two provided #8-32 screws
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
1
1
A
THUMB NUT
MOUNTING
CROSSBAR
FIXTURE
HOUSING
MOUNTING
CROSSBAR
B
#8-32 SCREW
ELECTRICAL
BOX HOLE
2
2
NOTE: To avoid insulation exposure use the provided
plastic gloves.
THREADED
STUD
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[e-mail]
VSKY-SQ-14-H1-_
VSKY-SQ-18-K1-_
VSKY-SQ-24-K1-_
© 2009 Edge Lighting. All Rights Reserved.
C
3
UNIVERSAL
CROSSBAR
4
4
FIXTURE ASSEMBLY
3: Connect the fixture green wire to the mounting crossbar
ground screw. Make sure that the mounting crossbar is
grounded in accordance with local electrical codes.
4: Connect each fixture wire to one power wire with a wire nut.