Owner manual

SAVE THESE INSTRUCTIONS!
FJP-4SF-_
- This product is ETL listed for indoor dry locations.
- This product is dimmable with a standard incandescent
dimmer.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
A
1: Loosen and remove the two #8-32 flat head screws from the
canopy to remove the crossbar.
Fast Jack Power 4" Surface Mount Canopy
Installation Instructions for
Install the Canopy
1
904-FJP-4SF-03
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
B
2: Turn the power to electrical box off.
3: Connect the white transformer wire to the neutral power
wire with a wire nut.
4: Connect the black transformer wire to the hot power wire
with a wire nut.
5: Place the transformer and transformer wires inside the
electrical box.
TRANSFORMER
4
5
CROSSBAR
1
#8-32 FLAT
HEAD SCREW
CANOPY
1
ELECTRICAL BOX
3
© 2009 Edge Lighting. All Rights Reserved.

Summary of content (2 pages)