User guide

9: Feed the pigtail wires through the cover hole and mount to
cover to the housing with the four #8-32 screws.
10: Repeat step 9 for the remaining housings.
Install Drywall, Trim & Lamp
I
3"
2
3"
1
1: Mark 3" square(s) on drywall where the housing opening is
(are) located.
2: Cut out the marked square(s) and install the drywall.
4
J
4
3: After installing drywall and finishing it, connect each wire coming out of the housing opening to one trim wire with a wire nut.
4: Place all wires inside the housing and gently push the trim into the housing opening by squeezing the side springs.
5: (Optional) - If slave housings are used, then repeat steps 3 and 4 for all slave housings.
DRYWALL
TRIM
3
H
COVER
#8-32 SCREW
10
NOTE: Each fixture contains a 2 watt integrated LED lamp. These lamps are rated for 40,000 hours.