User guide

3
Slave Step Kit Wiring
G
1: Run the proper low voltage wires to each housing by referring to the "Low Voltage Wire Size Chart" on page 2. The distances
are from the master housing to each slave housing. Refer to the wiring diagram above before proceeding with the steps
below.
2: Make sure the power to the LED power supply line voltage wires are off.
3: Starting with the master housing, connect one LED power supply wire to one low voltage (12VAC) wire going to adjacent
slave housing and to a 1 foot long low voltage pigtail wire with a wire nut.
4: Connect the other LED power supply wire to the other low voltage (12VAC) wire going to the adjacent slave housing and
another 1 foot long low voltage pigtail wire with a wire nut.
5: Continuing with the adjacent slave housing, connect one of the low voltage (12VAC) wires coming from the preceding
housing to a low voltage (12VAC) wire going to next slave housing and to a 1 foot long low voltage pigtail wire with a wire
nut.
6: Connect the other low voltage (12VAC) wire coming from the preceding housing to the other low voltage (12VAC) wire going
to the next slave housing and to a 1 foot long low voltage pigtail wire with a wire nut.
7: Repeat steps 4 through 6 for all other slave housing except the last one.
8: Make sure the low voltage (12VAC) wires coming from preceding housing to the last housing extends 1 foot out of the slave
housing.
1
1
2
3
4
5
6
7
HOUSING
MASTER TRIM SLAVE TRIM SLAVE TRIM
60W MAX
ELECTRONIC
LED DRIVER
WHITE (NEUTRAL)
BLACK (HOT)
STEP WIRING DIAGRAM
8
12VAC
120VAC
12VAC