User guide

A
HOUSING
WING NUT
SAVE THESE INSTRUCTIONS!
_
- This product is ETL listed for indoor dry locations.
- This fixture is wall mount only.
Installation Instructions for Step LED Kit
904-STEP-KIT-L-04
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[e-mail]
Install the Step Housing
1: Loosen the two top and bottom wing nuts on the housing to
remove the two mounting brackets.
1
© 2011 Edge Lighting. All Rights Reserved.
STEP-KIT-L1M_
STEP-KIT-L1S_
MOUNTING BRACKET
1
1
THREADED STUD
B
HOUSING LIP
WING NUT
MOUNTING
BRACKET
2
THREADED STUD
2: Mount one adjustable mounting bar to the top of the housing
by sliding it completely under the housing lip.
3: Replace the mounting bracket onto the threaded studs so
that the flange faces the adjustable mounting bar. Tighten
the wing nuts to secure the adjustable mounting bar in
place.
4: Repeat steps 2 and 3 for the bottom of the housing.
MOUNTING
BRACKET
FLANGE
3
5:
be mounted.
6: Place the adjustable mounting bars between the studs.
7: Make sure the lips on the adjustable mounting bars are
against the studs. Secure the adjustable bars to the
studs with the provided eight #8 screws.
Select the location between the two studs for the housing to
NOTE: The adjustable mounting bars mount to studs that are
spaced 16" to 24" apart.
C
STUD
ADJUSTABLE
MOUNTING BAR
7
6
#8 SCREW
7
7
7
ADJUSTABLE
MOUNTING BAR
4